1. Clean and Dry the Board
-
Rinse off any sand, dirt, or saltwater.
-
Make sure the board is completely dry before packing to prevent mold or odors.
2. Deflate the Board Fully
-
Open the valve and press the pin to release all the air.
-
Use the hand pump (deflation mode) to fully deflate the board.
-
You can gently press or roll parts of the board to help air escape, but do not fold yet.
3. Place the Board on a Flat Surface
-
Lay it out with the deck (the side with the foam pad) facing up.
4. Fold the Board
-
Start at the nose (front) of the board.
-
Fold it toward the tail in even sections—about 12–14 inches wide.
-
Keep the valve section toward the end so excess air can continue to escape as you roll.
5. Secure the Rolled Board
-
Once rolled, use the included straps to keep it tight and compact.
-
If the straps are missing, any sturdy buckle strap will work.
6. Pack Into the Carry Bag
-
Place the rolled board into the bag first.
-
Then pack the accessories:
-
Pump
-
Paddle (collapsed)
-
Leash
-
Fins
-
Repair kit
-
-
Keep loose fins in a side pocket or wrap them in soft material to prevent bending.
7. Add Padding if Shipping
(For returns or courier transport)
-
Add some bubble wrap or soft padding around the rolled board and accessories.
-
Ensure the valve and edges are cushioned to avoid impact damage.
8. Close and Seal the Bag
-
Zip it up securely.
-
If shipping, place the bag inside a cardboard box if possible, and tape it well.
